"

Cookies ussage consent

Our site saves small pieces of text information (cookies) on your device in order to deliver better content and for statistical purposes. You can disable the usage of cookies by changing the settings of your browser. By browsing our site without changing the browser settings you grant us permission to store that information on your device.

I agree, do not show this message again.

Fabrication of fiber grating by phase mask and its sensing application

BASHIR AHMED TAHIR1,* , JALIL ALI1, ROSLY ABDUL RAHMAN1

Affiliation

  1. Fiber Optics and Photonics Research Laboratory, Department of Physics, Faculty of Science, Universiti Teknologi Malaysia, 81310, Skudai, Johor, Malaysia

Abstract

This paper reports an investigation of a fabricated fiber grating device characteristics and its applications, using a phase mask writing technique. The phase mask technique used for writing fiber gratings has the advantages over the traditional holographic method because of its simpler writing setup and more reproducible characteristics. Specifically, the utilization of phase mask relaxes the strict requirement on the coherence of a UV light source. On the other hand, to photo induce an index change in the fiber core, light absorption must somehow occur. Alkins measured the absorption spectrum in a standard germanium doped mono mode telecommunication fiber to the wavelength as short as 200 nm. The results show that a light source in the UV spectral region 228 to 253 nm is most effective in photo inducing refractive index changes in such optical fibers. Therefore, we used a KrF excimer laser with wavelength ~248 nm as light source, and applied the phase mask technique to writing fiber grating. This method has the significant advantage for its much less relaxed requirement on the spatial coherence of exposure light source. The device (i-e grating) characteristics especially, in sensing application, were investigated. In addition, the possibility of using such device as a temperature and strain sensors is also discussed in detail..

Keywords

Fiber Bragg grating, Phase mask technique, KrF* excimer laser, Sensing application, Temperature and strain sensor.

Submitted at: May 5, 2006
Accepted at: July 20, 2006

Citation

BASHIR AHMED TAHIR, JALIL ALI, ROSLY ABDUL RAHMAN, Fabrication of fiber grating by phase mask and its sensing application, Journal of Optoelectronics and Advanced Materials Vol. 8, Iss. 4, pp. 1604-1609 (2006)