"

Cookies ussage consent

Our site saves small pieces of text information (cookies) on your device in order to deliver better content and for statistical purposes. You can disable the usage of cookies by changing the settings of your browser. By browsing our site without changing the browser settings you grant us permission to store that information on your device.

I agree, do not show this message again.

THE INFLUENCE OF THE SINTERING CONDITIONS ON THE TRANSPORT PROPERTIES OF La0.44Ho0.11Sr0.45MnO3-dddd AND Nd0.44Ho0.11Sr0.45MnO3-dddd COMPOUNDS

M. L. Craus1,* , N. Cornei2, C. Mita2, I. Berdan2

Affiliation

  1. National Institute of Research&Development TPI Iasi, Blvd. D. Mangeron 47, 6600 Iasi
  2. "Al. I. Cuza" University, Chemistry Faculty, Blvd.Carol I, 6600 Iasi, Romania

Abstract

The La0.44Ho0.11Sr0.45MnO3-d and Nd0.44Ho0.11Sr0.45MnO3-d compounds were obtained by sol gel method. The structure, magnetic and transport characteristics were investigated between 77 and 600 K. The lattice parameters of the sintered in air samples are smaller then those of the sintered in O2 samples. An important increase of the chemical disorder, in the same time with the decrease of the tolerance factor, was observed at the substitution of the La with Nd. The substitution of La with Nd leads to a decrease of the specific magnetization and of the Curie temperatures of the samples. The transition temperature from the metallic to the semiconductor state decreases for the samples sintered in air as compared with those sintered in O2. A decrease of the activation energy of the charge transport at temperatures higher than the transition temperature takes place also when the La is substituted with Nd..

Keywords

Perovskite, Manganite, Sol-gel method, Magnetic properties.

Submitted at: July 4, 2003
Accepted at: Aug. 21, 2003

Citation

M. L. Craus, N. Cornei, C. Mita, I. Berdan, THE INFLUENCE OF THE SINTERING CONDITIONS ON THE TRANSPORT PROPERTIES OF La0.44Ho0.11Sr0.45MnO3-dddd AND Nd0.44Ho0.11Sr0.45MnO3-dddd COMPOUNDS, Journal of Optoelectronics and Advanced Materials Vol. 5, Iss. 4, pp. 963-969 (2003)